Good to read that you are happier and more confident than you were initially and the BRP explanation does have merit especially item 2. You had a new engine just breaking in as well as a new power...
Type: Posts; User: AndysF3S
Good to read that you are happier and more confident than you were initially and the BRP explanation does have merit especially item 2. You had a new engine just breaking in as well as a new power...
You can order the plastic parts from the dealer but if you take the broken pieces off check that the metal support pieces are not bent. You can do the work yourself or take it to a Can am dealership,...
My tire pressure sticker for a 22 F3S is in the Frunk so you can check there. Mine says 15 psi front and 28 psi rear. FWIW
The first thing I would do is have your ride height checked and if necessary adjust the spring preload on the front shocks so that the front end is at the right height with you, passenger and cargo...
I sent my ECM to MFI in Ontario, and it took about 2 weeks from shipping to receive back. I asked Steve to leave my rev limiter at stock since it's harder to detect the tune at the dealership and I...
After riding the Spyder with the cat delete and baffles, I can say that the system is louder than stock but not obnoxious. My helmet helps to tone down some of the noise so that I don't need to wear...
I give you the last word, a full tank to the brim still has the air pocket???
I am aware that you can continue to fill the tank after the pump kicks off at the bottom of the baffle but from the Can am perspective they are trying to reduce evaporative emissions and the risk of...
I bought the F3S last July and I don't use the phone app or a communicator at all, the gas tank is what it is but over filling it to the top may get you evap problems down the road and I don't plan...
Page 63 of my 22 F3S Operators Manual says "see the Can Am dealer for front end adjustment" and page 292 of the shop manual gives you the rest of the info, including the recommended preload height of...
Have the dealer set the front ride height on the suspension, this means that you, a passenger and your expected luggage should be on the bike when the measurements are taken. They can then crank up...
WOT=acceleration=exhilaration, have to pull a couple of gears at WOT every ride to see if the Spyder is alive and well and the driver is alert. Not in traffic, only on the highway when it is safer to...
I haven't owned my Spyder long enough to have any history on the nylon gears but I do know that they were used by GM in some of the car engines (cam shaft sprocket - metal hub with a nylon running...
I doubt that it being lent to a "training school" on a closed course would have any adverse effect.
The cause of the rattle should be evident as others have stated once they take the belt cover...
I didn't have to, as the OEM was replaced under warranty late last fall. The LiFePo4 have a much lower discharge rate from my research and prefers to be stored at less than full charge, so you...
I did my new 22 F3S first service at about 2000 miles and was reminded by the dealer service writer several times that it was not required until later. It was last October and I wanted some fresh oil...
22 F3S
Open the frunk, remove the 4 push pins (one at each corner), remove the trim piece that covers the latch by pulling up at each corner to pull out the pins from the rubber grommets, pull...
You can trim the top bracket so that it drops down and secures the battery or you can use some small styrofoam spacers cut to size one on each side and pressed down into place. The top bracket does...
Maybe, just maybe there was toooo much instruction going on? Has she been a licensed vehicle driver for years or is she just learning to drive?
My suggestion is the same as the others, find and...
Thanks for posting the analysis, it is difficult to read but the comments in the upper part is where they talk about the oxidation number and not the TBN (total base number) which usually indicates...
I have removed the two up seat and footrests but have left the hand holds and shad brackets on in case I go for a several day ride. The hand hold brackets can be used for lashing something down over...
IMO: Anyone who plays on the highway when there is traffic is going to come to a sudden unplanned stop because you can't predict what other drivers will do. The total disregard for the other drivers...
I hope the EV Spyders are a long time coming and I won't own one, but the debate will switch to what size charger should I be using and what is the better battery and there are always tires and oil!
If the oil only had 200 miles on it when you tested it and it showed oxidation at 37 I would tend to question the accuracy of that test?
If the oil had 9000m on it when tested and it was changed...
I was searching the internet for local suppliers and came across this one:
https://www.ablithium.ca/product/13-2v-13-2ah-700cca-lifepo4-starter-battery-utvs-boats/
its rated at 12ah but has a...
I've owned my F3S for about 9 months now and use the kill switch to stop the engine so I am very aware of its location and other than using cruise control I don't multitask when driving the F3S.
...
I purchased my 22 F3S last June, it had the 2nd seat on it and I got the lockable storage replacement handed to me after the sale as it was included with the bike. That is why your bike already had...
Thanks for the replies, I just wanted to post what a difference the adjustment to ride height did for other folks that may be experiencing a wandering Spyder like I did. I have a Baja Ron sway bar,...
Cheapest and easiest is USPS, its slowest as well but no surprise fees like UPS.
Your battery is probably covered under warranty but get get it load checked asap. Mine was made in China and would flash a VSS code at every start even after putting a charger on it. It was replaced...