How To Properly and Stylishly Mount Mutazu Bags To An F3S - with pics

[Trevor G]

Fitting The Top Stabiliser Bracket

Take the button head 50mm x 8mm bolt purchased as extra and start fitting to it:

1) flat washer (rounded side against bolt head)

2) top stabiliser bracket (into the extra hole in the short arm)

3) flat washer (flat side against bracket)

4) 3/4" x 5/16" spacer purchased as extra

5) flat washer - flat side against spacer. The rounded side of this washer MUST fit against the plastic cover.


Upper stabiliser mounting.jpg


Insert the end of the bolt with components attached into the hole in the plastic cover removed earlier and screw it into the hole until at least a 1/2:" of thread is sticking through the cover.

Fit the edge of the cover closest to the tyre first, then wriggle it into place and screw the button head bolt into the 8mm T nut you fitted earlier. Screw this up until almost tight. Leave it loose enough so that the stabiliser bracket can rotate and tilt a little.


DSCF2239.jpg