'24 F3S Customer Accessory Circuits don't match manual - splice into them or... ??
Just bought a 2024 F3S and looking to add some lights. The manual states that there are 3 Customer accessory circuits available. One under the frunk; one, the left service panel; and one under the passenger seat. I’ve checked all three and they don’t look anything like what is in the manual, or what I had in previous Spyders. Do I need to splice directly into the wires to access these?
Last edited by Peter Aawen; 05-20-2024 at 06:03 PM.
Reason: Expanded title to briefly state the reason for this thread! ;-)
I have found the manuals to be generic in nature and missing most of the useful info.
Last edited by Peter Aawen; 05-20-2024 at 06:02 PM.
2024 RT Sea to Sky screen now working but codes will remain until BRP releases the ACP update.
2023 RT Sea to Sky Shadow Green (guess what? NO errors at all in 9 months of owning!) Such a sweet S2S :-)
A lot of folks here (me included) just added a small FUSE box connected to the battery and used that as needed. I think I paid $8.00 for 6 circuits .... see what "Banggood" has to offer. .... Mike
Last edited by Peter Aawen; 05-20-2024 at 06:03 PM.
ON my 2022 RTL there was no accessory wire on the right side, so I spliced into a wire labeled power using posi-taps. Installed my GPS and it powers up when my RTL is turned on.
Current: 2022 RTL SE6 Red Marsala and 2012 622 Trailer Lava Bronze,
Previous: 2014 RTL SE6 Black Currant - 58,746 miles,
2012 RTL SE5 Lava Bronze - 19,675 miles
Yes, there's a total of three and you may need to remove the left panel to see that one. You will need to remove the black cover to see the wires. You can attached a Splicing Connector to each wire for additional accessories
On my 22 F3S I have found and used all but the rear cust acc wiring.
If it's the same as mine , the wires will be taped together and then sealed. It's all black. The frunk wires to to the right of the battery looking at the spyder from the front. I had to dig mine out. They were hiding in plane sight.
The left side panel is where the 2nd customer accessory wiring is. It should also have a white tag indicating the cust acc wiring.
The rear looking from the back of the spyder it's under the
The seat or cowl on the left side looking fwd. Mine was two pinkish colored female spade butt connectors.
Last edited by Dasmoetorhead; 05-31-2024 at 01:14 PM.