-
What size wrench do I need
To remove the rear axle nut off of a 2012 RT limited,, thanks
-
Very Active Member
I usually like them about 5'-2" all the way up to maybe 5'-6".
That makes it easier to hold them and guide them lightly around the dance floor.
Smaller, and I wind up stooping down to them.
Taller, and I'll admit it, I feel inferior.
OOOPS silly me. I see you wanted to know about a wrench.
I thought you said WENCH.
My bad............................................
If it ain't broke, don't break it.
IBA #47122
2020 RT Limited Asphalt Grey
-
-
Very Active Member
36 mm socket and Big crescent or Crowfoot open end is a good investment..
Originally Posted by crochford
To remove the rear axle nut off of a 2012 RT limited,, thanks
I found a 1 7/16 inch crowfoot with a 1/2" drive on EBay pretty cheap.. it works well with a 1/2" drive torque wrench on the nut side while I hold backup with the 36 mm socket and 24" breaker bar.
-
-
Very Active Member
You already know it's a close fit between the nut and the muffler. No room for a socket. I find that this works well on the nut, and you can use the 36mm socket on the left side.
https://www.powersportsplace.com/par...2585/overview/
This also has a fitting for the torque wrench. Don't forget to adjust your torque value setting on the torque wrench to account for the increase in length if you use it.
Doug
2023 RT Limited, RT 622, BUDS/BUD2 Megatech/Megatronic
”Freedom is not a loophole”
F4 Customs SWCV, Ultimate, Lidlox, Adjustable Side Vents, Leather Like Grips, SS Grills, Centramatic, Garmin XT2, BajaRon Original Sway Bar w/ Lamonster links, P238
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|