• There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.

Recent content by EdMat

  1. EdMat

    Spyder - Trader Joe's - A case of Two buck chuck will fit!

    The things we will do to carry an ill fitting load. ;)
  2. EdMat

    After some Rear axle O-ring information - what's the correct size?

    If you can find the right diameter 'O' ring material you can make one. You just need to add a razor knife and a drop of superglue.
  3. EdMat

    Changed my Spark plugs/HCM filter/oil and filter/fuel filter - Shifts better now!

    They just did a very through flush job. ;)
  4. EdMat

    Help - new tires and wheel speed sensor errors - Limp Mode with Codes C006C, C003A, C1290, & P2159. Anyone else? Any advice?

    While you can pick up some good tips watching Shawn's vids you have to remember that BRP furnishes him a new loaner every year, he works for a Can-Am dealer, and he makes money off his YouTube vids. He's not going to vary too much from the official BRP line.
  5. EdMat

    What color Touch up paint for 2015 rear sprocket? Any tips?

    Fingernail polish is also good for small scratches.
  6. EdMat

    Help - new tires and wheel speed sensor errors - Limp Mode with Codes C006C, C003A, C1290, & P2159. Anyone else? Any advice?

    Your dealer just feed you a long line of BS. An aftermarket brake rotor would have no effect. Probably what happened is when the wheel sensor was removed the shims fell off or were not put back on correctly, causing the sensor to sensor wheel to be distanced incorrectly. Worst case, it would...
  7. EdMat

    Has anyone used a 'Thru the dipstick' 12v Oil extractor on a Spyder?

    Due to the configuration of the engine you will be leaving a lot of old oil.
  8. EdMat

    Can anyone tell me what this tray in the RT Trunk is?

    That tray is a blessing and a pain. The velcro for the rear does not hold all that well, so you have to have the space below the tray taken up with something. That's were I keep tire repair, small air comp, jump starter, tools, etc. That leaves a bunch of room above the tray for quick access...
  9. EdMat

    Let’s start a fad - passing Spider Rings (from Amazon) to other Spyders

    Almost always have a bell to pass to someone I meet along the way
  10. EdMat

    What is the current FOBO2 Firmware Version?

    1.03.06 looks like the latest version.
  11. EdMat

    1330cc Can I change the Transmission Filter without dumping the oil?

    I would venture a guess that most on here who have changed their own HCM filter have done so without using BUDS.
  12. EdMat

    Just found these RPM levels for the 1330

    The shift points you see above 4K are for the 998 engine not the 1300. I have found depending on gear and traffic I shift the 1330 anywhere from 2300 to 4000 with the occasional run up to 6500 when in a hurry. Have you noticed with the 1330 that if you try to shift and it thinks the RPM's are...
  13. EdMat

    Wrapped my 2021 RT Limited

    Looks like they did a very good job. Nice color.
  14. EdMat

    Why does the BRP Oil Change Kit have 5.5 quarts of oil?

    Additional oil is needed when it's time to change out the HCM filter. Plus, the 10th one is free if you save it up. :)
  15. EdMat

    Oil - Full Synthetic or Synthetic Blend??

    Just don't mention that it is also rated for diesel engine service.
See more
Back
Top