GS Rear LEDs Complete!

[Sarge707]

When I "Lost" the rear fender I had access to the wiring real easy so added-

1- 2 12 inch LED strips to side of underpanel and 2 4 inch LEDs over Plate (Not Visable)? Running Lights Cost $35 Advanced Auto.

2- Today I finished with 2 12 Inch Mega Bright LEDs under the rear that are only wired to the Brake (White )wire and ground. $35


My MudFlap Lights are pettibuilt truck light from Superbrightleds.com and were $10 Each.

Inexpensive (Cheap) Farkeuiolisis!!!:roflblack:

 

[Chupaca]

Nicely done..!!

awesome. Good job all the work paid off..!! Congrats....:2thumbs:

 

[billrob71]

Looks nice :congrats:

 

[MikeinGA]

Look great! I have the LED's on my 2011 RS-S on the splash panel like yours. They work when car or truck is behind me, when I hit the brakes they back off.

Mike

 

[Flanker]

Looks nice; what color jacket/clothing do you wear when you ride?

 

[ARtraveler]

Very nice looking lights. They sure "up" the visibility factor. :thumbup:

 

[Brogers57]

Do these run while the bike is started then brighten when the brake has been pressed? Which wires did you tap into?

 

[Sarge707]

Do these run while the bike is started then brighten when the brake has been pressed? Which wires did you tap into?

I had the fender light wire to work with because I removed the fender!
You basically use posi taps to tap into a Black wire (Under Back) for ground, orange wire for running and white wire for Brake.

Tric Leds (Vendor on Home page) has a kit with the lights on the side of the wheel cover thats plug and play and act as (Dual Intensity) Running and Brake. I would have bought those if I didn,t already have the side lights and then I would Not have had to add the MegaLight LEDS you see under when the brake is applied. Check them out at Tricled?

Positaps are (IMO) the best connectors.

 

[Brogers57]

Completed mine today with just 1 strip under each fender.

 

[danlnc]

I did the same setup on my RSS. I bought a 16 foot roll of led strip from Hitlights for about 20 bucks. With the clip they sell I cut 2 strips one on each side from where the side tupper ware starts to the Tail. I have a Bestem trunk which I removed the reflector and installed a double strip of leds there. I still have 2 feet left over.