Dan McNally
New member
A while back, my former dealer replaced the parking brake cable during the 2013 RT recall work, because it had melted. Shortly after I got home, I discovered they had left a piece off the brake assembly on the rear wheel, that connects the parking brake cable to the brake. See the photo, below. I was going to go to another dealer, a couple hours away, but got caught up in jury duty, and by the time that ended, the snow had started flying near there, and I haven't had a day where the entire route is clear . . . so haven't gotten there. I broke down and ordered the cable support assembly from CanAm. The second photo shows what came in the bag. I've numbered the parts. Parts 7 and 8 are already installed, as they were not removed by the dealer. I know that I need parts 1, 2, and 3 . . . but need someone to tell me if the washers (labeled 5 & 6) or the rubber piece (labeled 4) are part of what is missing. and, if so, what sequence do they go on, starting at the star shaped part on the brake that part 1 fits over . . . The parts break down of the brake assembly at the CanAm web site does not go into that level of detail . . . Thanks in advance for the assist.



