I have seen cluster problems here but none like mine. I have 2012 rt with 7000 miles only. Bike does start & run but cluster is blank, windshield , turn signals headlight controls, & reverse do not work. Only thing that works on that multi function control set up is the horn. Any help would be greatly appreciated, in my 70's retired & on Social Security only---dealer is way two $$$$$. Thanks
-
There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.
electronics not working
- Thread starter DenP
- Start date
billybovine
Active member
Check fuse F1 in the front fuse box.
IdahoMtnSpyder
Active member
The horn is the only function in that switch that does not use the CanBus. First, check F1 in the left fuse box. If it is good then I suspect the left switch, which uses a processor on a circuit board for its operation, has gone south. That is, unless there is a bad ground in the switch circuit. Does your cruise control work? If not that points to the left switch module since the cc on/off signal goes through the left switch.
Thought cruise control went through the RIGHT switch block. Thats where the controls are.
IdahoMtnSpyder
Active member
That's where the buttons are but they connect to the processor in the left handlebar.
Similar threads
- Sticky
