YouTube

[Utah Geezer]

Just received my Spyderpops stainless steel Kott Grilles for my 2014 RT LTD. Instructions are ok but thought a YouTube video of them being installed would be even better. Went to YouTube and dang if there isn't any posted. Anyone know of any that I'm not finding or looking in the right place for.

 

[JayBros]

The son says I'm a geezer too but I found it was a bit easier on the old bones when the front wheels were on my wheel ramps. Had it up there anyway to install the bump skid. It's really a very simple job and they're a great product.

 

[ARtraveler]

Me too! I have a set ready to install, since before I put the :spyder2: to sleep for the winter. The thought of having to get down on the concrete floor of the garage and getting them just right has been causing me to hold off until that first 50 degree day or so.

Also will need help getting up off the floor. :roflblack::roflblack:

Bottom line though: they look great and I am going to have the spiffiest looking :ani29: of the two in the garage. :yes:

 

[Marker]

I have a set too going to ask my fellow spyder ryder that lives close by if I can use his lift.
My bones are a lot older than what the birth certificate says

 

[JayBros]

My bones are a lot older than what the birth certificate says

It's obviously a state of mind or we wouldn't be riding these things!

 

[Chupaca]

Curious..!!

don't you just pull the panels..?? Then take them inside and do it on the kitchen table while watching some good movie or listening to some great tunes...:roflblack:

 

[Cruzr Joe]

one thing i will tell you if you want to have problem free KOTT grills .............................. be sure to clean the area and then clean it again with alcohol and then use the adhesive enhancer .

(ok so it was more than one thing)

Cruzr Joe

 

[OwnerOfHarriet]

do you just drive the spyder onto the ramps? or raise it and place the ramps underneath? where is the lift point?

 

[jimnsusie]

Been putting off getting mine done also. Keep forgetting to get the magnetic catch that I saw on another thread. That looked like a good idea

 

[JayBros]

do you just drive the spyder onto the ramps? or raise it and place the ramps underneath? where is the lift point?

Just drive it up, very slowly. There's an OP here who backs his onto three ramps -- would keep it level for an oil change.

 

[Cruzr Joe]

Been putting off getting mine done also. Keep forgetting to get the magnetic catch that I saw on another thread. That looked like a good idea

Magnetic catch??? :hun: these are stainless steel, magnets don't work on stainless steel.

(after i posted this, i went over to mine with a magnet to make sure i was right, i was. :roflblack

Cruzr Joe

 

[ThreeWheels]

do you just drive the spyder onto the ramps? or raise it and place the ramps underneath? where is the lift point?

Just drive it up the ramps.

 

[Utah Geezer]

Gotter Done

Decided to just getter done this morning. Attacked it and in an hour I had them all on. Looks good and wasn't too bad. Decided to get the Show Chrome Luggage Rack put on today too. Took about the same amount of time. Two projects done and many more to go.

 

[jimnsusie]

Magnetic catch??? :hun: these are stainless steel, magnets don't work on stainless steel.

(after i posted this, i went over to mine with a magnet to make sure i was right, i was. :roflblack

Cruzr Joe

There's a thread about this very thing. They explained it and had pictures. Sounds like it works. Anyway that's how I am going to do mine.