Can anyone confirm the 2021 F3-S Rear Axle Nut Size?

[Hogmonster]

Hi All,
I have tried searching for this as I'm sure it's been discussed.
Can someone confirm the rear axle nut size please, my machine is in storage so it's not easy to measure it.

Also do people replace the nut after removal or use loctite on it?

Regards Andrew (UK).

 

[Mikey]

It's an M24

 

[Vinkon]

Hi All,
I have tried searching for this as I'm sure it's been discussed.
Can someone confirm the rear axle nut size please, my machine is in storage so it's not easy to measure it.

Also do people replace the nut after removal or use loctite on it?

Regards Andrew (UK).

36mm socket to remove, reuse nut, no loctite.

 

[Snoking1127]

It's an M24

M24 is thread size, the wrench required is 36mm.

 

[Mikey]

thank you

 

[Hogmonster]

Thank you guys for your helpful replies.

 

[pauly1]

The axle nut size requires a 36 mm wrench.

 

[Snoking1127]

The axle nut size requires a 36 mm wrench.

I have a LARGE 36mm end wrench, a 36mm socket and a torque wrench that goes to 250 lb ft to be able to torque the axle nut to the required 166 lb ft.

 

[Woodaddict]

The 36mm socket can be used on the filter cap also. Get a hex 36mm socket, not the 12 point. Will fit better for axle nut and plastic filter nut

 

[Hogmonster]

The 36mm socket can be used on the filter cap also. Get a hex 36mm socket, not the 12 point. Will fit better for axle nut and plastic filter nut

Hi, yes I prefer 6 sided sockets too, less chance of slipping or rounding corners. Thanks again for everyone's input, socket ordered.