USB Outlet

[Cruising RT]

Just purchased a USB Outlet from Lamonster. Wanted to install between heated grip control and ride suspension control and once I looked under the blank I noticed the round hole, and the USB Outlet is rectangular. Does anyone have a video to share a DIY video on install. Thanks in advance for any help.:spyder::spyder::spyder::bowdown::bowdown::bowdown:

 

[jwulf74]

I don't have a video, but I made a template out if cardboard that the switch fit tight into and the aligned it around the round hole. Mark as desired and then I used a razor blade to cut it out leaving it slightly smaller and then shaving it down for a right fit.

 

[LJspydee]

Switch install

I installed an auxillary power switch in that location. I measured the switch and taped off the hole size. I used an exacto knife to cut out the rectangular hole. The switch popped into the hole just like OEM switches.

 

[KJWEB]

That is where I put my dual USB port. I used a template I made of the switch and then used a dremel to cut it out.

 

[Hokiev]

USB - Wire to where?

Where do you all wire your switch. I have to still cut out the hole, just not sure where to tap to get power.

Any help is appreciated.

 

[justcalldon]

Yes I would like to know where to get the power from too.


Justcalldon

 

[KJWEB]

Mine in wired directly to the battery with a 15amp in line fuse. One of the forum sponsors JT sells the dual usb and wire kit